Shutting off Water during Flooding in East Topeka, KS

8/5/2024 (Permalink)

  This article gives you instructions to:

• Shut off the main valve at the water source
• Shut off water supply valves in all parts of your home
• Check your water valves and pipes for leaks

      When pipes burst, plumbing leaks, or appliances cause a flood, cut off the water at its source IMMEDIATELY. Water damage from frozen pipes, ruptured washer hoses, leaking supply lines and dripping water heaters cost billions every year. Avoid major water damage problems in your East Topeka house by knowing how to shut off your water.

      Take a moment right now to locate all of the shutoff valves in your home so you’ll be prepared for an emergency.

     How to Locate the Whole-House Water Shutoff Valve-

      The most important point to know in a flooding emergency is your East Topeka home’s main water valve to shut off water at the source.

      This valve is located around waist level or lower, on the inside basement wall, closest to your street or well, where the water comes in from outside the home.

      Many water meter setups have two valves, one on the street side of the meter and one on the house side. You’ll typically find the main shutoff in the basement near the front of the house.

       If you pipe in water from the city, the water meter is always mounted next to the main, and the valve itself will be large, metal and have a very sturdy handle. In a home with metered water, look for the shutoff on either side of the water meter. Your meter could be located in the basement, mounted on an exterior wall, or even out near the street in a concrete “meter pit” where the household feed line meets the utility main.

      For a home served by a well, the shutoff will be on the house side of the pressure tank. You should also cut power to the tank so it doesn’t detect a phantom pressure loss and burn out trying to compensate.

      It could be outside your East Topeka home attached to an exterior wall or in an underground box with a removable lid.

There are two types of main shutoff valves: the gate valve and the ball valve.

      The gate valve is common in older homes and has a round handle that must be turned a number of times to open or close the valve. Gate valves are designed to be fully open or fully closed. Water flowing through a partially open gate valve can wear away the metal and cause the valve to fail over time.

      The ball valve is more common in newer construction and has a lever handle that needs to be turned 90 degrees to turn the water on or off. You can immediately tell if it’s open or not: in the closed position, the lever is perpendicular to the pipes; in the open position it’s parallel.

      If you’ve never shut off the main water valve before, test it to make sure it turned everything off. Turn on a faucet somewhere in the house and shut off the main water valve. All water flow should stop.

      An old gate valve can break, so be gentle when you’re handling it, if the valve is stuck, leave it alone. If it leaks or doesn’t shut off all the way, replace the valve. You’ll need to call your water department (and possibly pay a small fee) to have the water to your house turned off at the curb during repairs.

      If you have a well, shut off the electrical switch for the well when you leave for an extended period so it won’t pump any water while you’re gone.

The Science of Drying in Richland, KS

10/18/2023 (Permalink)

Did you know there is actually a science behind the process of drying? Having the knowledge of psychometrics is essential to restoring a water damaged structure to its pre loss condition. If your East Topeka business or home suffers a water damage, the team here at SERVPRO of East Topeka will:

• Inspect the building to detect every component that is wet to help prevent secondary damage from happening.

• Measure how much moisture is in wet materials and monitor whether the materials are drying properly.

• Speed up Mother Nature by using professional drying equipment.

What exactly does it mean to help “speed up Mother Nature”? A wet building can often dry naturally because the environment always seeks equilibrium. When materials are wet, moisture will naturally move to drier air at the surface of the material-but only if the air is drier. The only problem with nature is, nature often takes too long and secondary damages may occur while the building is drying out. SERVPRO of East Topeka has the professional training and equipment to help make water damage “Like it never even happened.”